PSM Rear Upper Control Arm for S, Z, R chassis cars

Scarles is the home of Parts shop max in NZ and Australia Check out the full range on their website https://store.partsshopmax.com/

Listing is for:
1x Pair of rear camber arms

~ Clears driveshaft shop 900hp axles with our drop knuckles, and nearly every other parts combination on earth * With exception of an S13 with long coil over springs, OEM knuckle and traction rod. 

~ lifetime manufacturers defect warranty 

~ Japan DOM tubular construction 

~ PTFE lined low torque spherical bearings 

~ Forged Clamping rod end receiver 

~ Forged Clamping adjuster 

~ Forged super long rod end has the most thread overlap and more adjustability than anything on the market 

~ Bell shaped high surface area pillowball side spacers reinforce subframe mount & give freedom of PB motion 

~ Laser cut 5mm thick 1 piece fork with reinforcement 

~ 3 stage copper paint finish

* Our length priority is for max thread overlap and strength when going for Zero camber (for best drift tire wear and traction) however the fitment crowd is always asking what the negative camber ability is. 

That involves variables like RLCA length, ride height, and combining with subframe risers and drop knuckles changes the camber gain upon compression too. 

With the jam nuts removed ours is 11.5" or 292mm & stock is 12.125" or 308mm.

Suits:
Nissan
S13 Silvia
S14 Silvia
S15 Silvia
C33 Laurel
C34 Laurel
C35 Laurel
R32 Skyline
R33 Skyline
R34 Skyline
A31 Cefiro