GKTech

GKTECH Z33 350Z/V35 V2 SUPER LOCK COMBO (Order in)

SKU: SCR GKT0547

$4,254.99

*NOTE* Currently is an order in product from GKTECH In Australia. Takes roughly 3-4 weeks

Listing is for:
1x Pair of V2 Z33 350z/ V35 4130 Chromoly Super Lock Lower Control Arms
1x Pair of Z33 350z/ V35 4130 Super Lock drift knuckles
1x Pair of M14 Super Adjustable Inner Tie Rod - Long Tie Rod
1x Pair of V2 Z33 350Z/V35 Front Upper Camber Arms (FUCA'S)

The GKTECH Super Lock combo is designed for those that are looking for a combo to get everything at once, install it and dial it in with some seat time.

As opposed to piecing a kit together one by one, which ends up costing more in the long run and can be more frustrating, we do recommend doing things once and doing things right.

This means it is a good opportunity to get everything you need at the same time!

Below if a brief explanation of the products in this combo, however, more information can be seen in the links provided;

Super Lock Chromoly LCA's

The Super Lock LCA's are only available in the one length which at its minimum length starts at +25mm over OEM and adjust out to +50mm from OEM.

Super Lock Knuckles
Our drop knuckles offer 30mm roll center correction, optimised camber gain in roll and bump, reduced inbuilt caster for a flatter contact patch and more consistent feedback, increased steering speed, bump steer and ackerman adjustment. They are not for the faint hearted with supporting in around 70 degrees of steering angle!

If you wanted to run ABS with our knuckles we have an option to add a bracket to hold the ABS sensor as well just let us know if you want to add one when placing the order

Inner Tie rods
Depending on whether you run rack spacers or not and also the length that you set the LCA at you will need different length inner tie rods. We have made 14mm tie inner tie rods that had enough adjustment to suit any configuration with our LCA's/knuckles.

Front Upper camber arms?
If purchasing our front lower control arms, they will push the bottom of the wheel out, resulting in more negative camber.

Our upper camber arms allow adjustment of the upper arm, fixing that issue. As well as eliminating the OEM rubber bushes, which allow zero flex and have zero chill when in operation. These are replaced with super smooth rose joints, allowing the arm to operate on its correct pane!

The GKTech V2 FUCA's allow for both camber caster and adjustment and new to the V2's is that they are adjustable in situ which will save you a load in setup costs.

Optional items in the photo that are sold separately:
Z33 350z Super Lock Drift Knuckle ABS sensor holder (PAIR)
4130 high tensile steel steering rack spacer
V2 4130 high tensile offset steering rack extenders

Suits:
NISSAN
V35 SKYLINE
Z33 350Z

Recently viewed